|
|
|
|
Thread Tools | Display Modes |
05-06-2021, 08:40 PM | #1 |
Scooby Newbie
Member#: 523449
Join Date: Apr 2021
|
02 Impreza wrx manual swap
How do I make the speed sensor work for my manual swap from a 05 legacy gt to 02 Impreza wrx ? And also if anyone knows how to wire everything else that would be a plus thanks in advance .
* Registered users of the site do not see these ads.
|
05-06-2021, 09:03 PM | #2 |
Scooby Specialist
Member#: 395793
Join Date: Jul 2014
Chapter/Region:
Tri-State
Location: SLC and Lake Placid
Vehicle:2005 92x Aero Beige |
Legacy measured speed at the hub. Your WRX measured speed in the trans. You have to open up the trans and add everything for the speed sensor to use one from a Legacy.
|
05-07-2021, 10:37 PM | #3 | |
Scooby Newbie
Member#: 523449
Join Date: Apr 2021
|
Quote:
Aaah ok makes sense but also another question what do I do about the axles since the lgt axles are shorter ? |
|
05-07-2021, 10:49 PM | #4 |
Scooby Specialist
Member#: 395793
Join Date: Jul 2014
Chapter/Region:
Tri-State
Location: SLC and Lake Placid
Vehicle:2005 92x Aero Beige |
Legacy was almost identical width as the WRX. How much shorter are they?
If they don't work just get 05 WRX CV axles. They will have the correct male input shaft. |
05-11-2021, 08:48 AM | #5 | |
Scooby Newbie
Member#: 523449
Join Date: Apr 2021
|
Quote:
My bad for the late response got a new phone but their like half an inch shorter I believe I can add a picture if need and will 05 wrx ones work then ? With the legacy trans and length? |
|
05-11-2021, 10:11 AM | #6 |
Scooby Specialist
Member#: 395793
Join Date: Jul 2014
Chapter/Region:
Tri-State
Location: SLC and Lake Placid
Vehicle:2005 92x Aero Beige |
Car dimensions change, not the transmission size unless you're talking about 5 vs 6 speed trans. And that's only in terms of length since the 6 speed is a little longer than 5 speed. 05 WRX cv axles will work
|
05-11-2021, 11:36 AM | #7 |
Scooby Newbie
Member#: 523449
Join Date: Apr 2021
|
|
06-10-2021, 05:19 PM | #8 |
Scooby Newbie
Member#: 524800
Join Date: Jun 2021
|
|
Thread Tools | |
Display Modes | |
|
|