|
|
|
|
Thread Tools | Display Modes |
05-06-2020, 08:58 AM | #1 |
Scooby Specialist
Member#: 97147
Join Date: Sep 2005
Chapter/Region:
NESIC
Location: Vermont
Vehicle:2012 wrx gray |
Knock sensor wire connector
Hi, need some help. When I pulled the intake manifold off my 06 WRX I accidentally pulled the wires out of the harness connector for my knock sensor. I fixed the connector, but I'm not sure of the polarity. I have a black wire(ground) and a white wire(5v?). Not sure which pins they connect to. Not even sure polarity matters, but would like confirmation. Any pics would help. Hope I explained my issue.enough, if not please let me know. Thanks!
* Registered users of the site do not see these ads.
|
05-08-2020, 12:11 AM | #2 |
Scooby Newbie
Member#: 3409
Join Date: Jan 2001
Chapter/Region:
NWIC
Location: Oly
Vehicle:98 My FMIC Is bigger than yours. |
White wire is pin 1, black is pin 2. Look at your crankshaft position sensor connector - white wire on that is pin 1 as well.
|
05-08-2020, 04:04 PM | #3 |
Scooby Specialist
Member#: 97147
Join Date: Sep 2005
Chapter/Region:
NESIC
Location: Vermont
Vehicle:2012 wrx gray |
Thanks, pin 1 is the one on the left, looking at the harness connector. Don't suppose you could take a picture.
Last edited by Vtwrx04; 05-08-2020 at 06:07 PM. |
Thread Tools | |
Display Modes | |
|
|