|
|
|
|
Thread Tools | Display Modes |
11-03-2020, 08:54 PM | #1 |
Scooby Specialist
Member Sales Rating: (9)
Member#: 263322
Join Date: Nov 2010
Chapter/Region:
NESIC
Location: Boston MA
Vehicle:2011 WRX Limited WRBP |
Alpine iLX-W650 Headunit [SOLD]
SOLD
Located in Boston, MA Buyer responsible for installation. Selling a near new (used for less than 4 months) Alpine iLX-W650 headunit setup. Would prefer to sell to someone with a 11-14 WRX with factory navigation as this is a complete setup and near plug & play. Harness is pre-wired for a 2011 WRX with factory navigation. The wiring harness is soldered and heatshrinked then wrapped together. You will however need to splice 2 wires from the Maestro SW unit into the factory 24-pin harness for steering wheel controls (diagram below). I tried very hard to avoid splicing into the factory harness but could not find a way around this. I would recommend using the T-splice method to accomplish this as it had very minimal impact to the factory harness and easily reversible. Other than that this is plug & play and there is plenty of additional wiring if you need to make adjustments. I've also wired in a parking brake bypass into the harness (not seen in pics as the unit is wrapped up. Also including a JDM radio bezel (pictured) Spec list of headunit components:
* Registered users of the site do not see these ads.
Last edited by olazy; 01-05-2021 at 09:18 AM. |
Thread Tools | |
Display Modes | |
|
|