EJ207 16bit to 32bit conversion

spiralsmurf · 02-28-2021, 09:29 PM

Has anyone ever used a signal conditioner to convert the 2 wire cam position sensor to provide a square wave output like a Hall effect (3 wire) sensor. This should negate the need to do anything with the cams and sensors.

http://jbperf.com/dual_VR/v2_1.html

* Registered users of the site do not see these ads.

ERMAHGERD SURBARRUR · 03-04-2021, 07:46 PM

Following

wrxmaster617 · 04-01-2021, 12:14 PM

subscribed

02-28-2021, 09:29 PM	#1
spiralsmurf Scooby Specialist Member#: 16085 Join Date: Mar 2002 Chapter/Region: SCIC Location: Chatsworth, CA Vehicle: 2005 STi Black	EJ207 16bit to 32bit conversion Has anyone ever used a signal conditioner to convert the 2 wire cam position sensor to provide a square wave output like a Hall effect (3 wire) sensor. This should negate the need to do anything with the cams and sensors. http://jbperf.com/dual_VR/v2_1.html * Registered users of the site do not see these ads.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-04-2021, 07:46 PM	#2
ERMAHGERD SURBARRUR Scooby Newbie Member#: 455314 Join Date: Sep 2016 Location: Georgia Vehicle: 2006 WRX wagon	Following

04-01-2021, 12:14 PM	#3
wrxmaster617 Scooby Newbie Member#: 289814 Join Date: Jul 2011 Chapter/Region: NESIC Location: Bristol county Vehicle: 08 Sti hatch Dgm	subscribed