|
|
|
|
Thread Tools | Display Modes |
04-04-2021, 03:31 PM | #1 |
Scooby Newbie
Member#: 522254
Join Date: Feb 2021
Chapter/Region:
South East
Vehicle:2020 WRX Base WR Blue |
2020 WRX OLM LED Turn Signal Bezel Hyperblink
Recently installed the Subispeed LED DRL Headlights for base WRX and the OLM LED turn signal bezel. Everything with the headlights, DRLs, and hazards are working correctly.
After installing the hyperblink module, I lose my right turn signal completely and still have hyperblink on the left signal. I followed all the instructions from Subispeed, clipped the tine off of add a fuse, and have verified its plugged into the right spot on the fuse box. Has anyone experienced this before? Is it possible I received a bad hyperblink module?
* Registered users of the site do not see these ads.
|
04-04-2021, 08:54 PM | #2 |
Scooby Guru
Member#: 53443
Join Date: Jan 2004
Location: Anchorage, AK
Vehicle:2001 LL Bean Outback Winestone |
To verify the wiring to the right side lights is okay I would first check the resistance to the lights at the module and compare the left and right side readings. If they are close to the same readings then I would think that part of the wiring is good.
|
Thread Tools | |
Display Modes | |
|
|