|
|
|
|
Thread Tools | Display Modes |
05-24-2017, 10:10 AM | #1 |
NASIOC Vendor
Member#: 198281
Join Date: Dec 2008
Chapter/Region:
MAIC
Location: Virginia
Vehicle:2005 WRX/STi WRB of course |
Tool for Welding EWG stubs into the Up-Pipe
We made some extras of these.
It's a 6061 EWG inlet flange adapter for a Tial MV-S (38mm). Can probably be used with a CompGate 40 too. Finned for cooling to control heat and keep the flange flat, with a 1/8NPT purge port. Shoot me a PM if you're interested.
* Registered users of the site do not see these ads.
|
10-03-2017, 12:34 PM | #2 |
Scooby Guru
Member#: 103232
Join Date: Dec 2005
Chapter/Region:
Tri-State
Location: GTX3576R 05GD, GTX3076R'd FXT
Vehicle:GTX 3071R'd 11WRX PPG,4.44,LSD,E85,6spdx3 |
How did I never see this? Did you ever make them for a 44mmTial/45mmTurboSmart Vband?
|
10-03-2017, 01:56 PM | #3 | |
NASIOC Vendor
Member#: 198281
Join Date: Dec 2008
Chapter/Region:
MAIC
Location: Virginia
Vehicle:2005 WRX/STi WRB of course |
Quote:
You shouldn't need to run a 44mm on these cars, unless you're running low boost or have a very poor EWG stud setup. The 38mm will give you better boost modulation and even reduce high flow turbulence some |
|
11-03-2017, 04:06 PM | #4 |
NASIOC Vendor
Member#: 198281
Join Date: Dec 2008
Chapter/Region:
MAIC
Location: Virginia
Vehicle:2005 WRX/STi WRB of course |
|
11-10-2020, 02:45 PM | #5 |
NASIOC Vendor
Member#: 198281
Join Date: Dec 2008
Chapter/Region:
MAIC
Location: Virginia
Vehicle:2005 WRX/STi WRB of course |
Bumping this from the dead. We have one left. They work awesome for keeping the EWG flanges nice a F-L-A-T
|
Thread Tools | |
Display Modes | |
|
|