|
|
|
|
Thread Tools | Display Modes |
03-13-2021, 05:31 PM | #1 |
Scooby Newbie
Member#: 522960
Join Date: Mar 2021
|
Accessport issues 2014 wrx
I just installled the v3 accessport last night, and followed all the necassary steps to install it including updating firmware and selecting the basic stage one map. As soon as the instalation was complete i waited about 20 seconds then started the engine. I was given 6 codes p2008,p2011,p2o16,p2021,p2431,p2433. the CEL was not on before the install.I took it around the block and noticed i am getting little to no boost in certain gears.If someone could point me in the right direction as where to even start i would greatly appreciate it.
* Registered users of the site do not see these ads.
|
03-13-2021, 06:04 PM | #2 |
Scooby Guru
Member#: 50586
Join Date: Dec 2003
Chapter/Region:
BAIC
Location: Chiraq
Vehicle:64 Impala |
did you try to uninstall the AP to see if it goes away???
|
03-13-2021, 06:41 PM | #3 |
Scooby Newbie
Member#: 522960
Join Date: Mar 2021
|
|
03-13-2021, 09:33 PM | #4 |
Scooby Newbie
Member#: 522960
Join Date: Mar 2021
|
|
03-24-2021, 09:31 AM | #5 | |
Scooby Newbie
Member#: 523117
Join Date: Mar 2021
Vehicle:2020 Sti |
Cobb Ap
Quote:
|
|
Thread Tools | |
Display Modes | |
|
|