|
|
|
|
Thread Tools | Display Modes |
12-30-2020, 03:18 PM | #1 |
Scooby Newbie
Member#: 406087
Join Date: Nov 2014
Chapter/Region:
Tri-State
Location: New York City
Vehicle:06 GGB 6sp Wagon WRB |
Excessive Shifter Up & Down Travel (am i missing something?)
Just finished swapping in a JDM Non-DCCD Sti Trans (2002-2003) into my 06 WRX Wagon a few weeks back. I purchased TIC's Holy Shift bushings combo and installed a Cobb STS. But, i've always noticed there is a considerable amount of movement up and down if i pull up on the shifter itself and it doesn't at all seem normal to me. I was beginning to thing I hadn't put in the Pivot cup & C-Clip so i ordered those (and the 2 orings) but I went to the car earlier just to poke around and realized it's all there so my question is, is there something that is supposed to go under the pivot cup? I feel like i'm definitely missing something. I've been looking at parts diagrams but can't really find a solid answer on what i may need.
Video for reference (don't mind the overly applied grease!) Do i possibly have the wrong stay bushing/pivot cup?
* Registered users of the site do not see these ads.
Last edited by AceKingNYC; 12-30-2020 at 04:57 PM. Reason: correcting video link |
12-30-2020, 08:29 PM | #2 |
Scooby Guru
Member#: 487
Join Date: Nov 1999
Chapter/Region:
TXIC
Location: Houston TX
Vehicle:1998 /2005 STunIcorn Acadia Green USDM 22b |
Man something is missing
Hard to see bc of the gray grease..... But Where is the white Teflon cup that bottom ball of shifter snaps into? Trying to remember my short shifter install Def know was not that loose/sloppy up and down |
12-31-2020, 07:20 AM | #3 | |
Scooby Newbie
Member#: 406087
Join Date: Nov 2014
Chapter/Region:
Tri-State
Location: New York City
Vehicle:06 GGB 6sp Wagon WRB |
Quote:
It's there, it's just covered in grease. I have a new cup, O-rings, and C clip arriving today. I am going to clean everything off and try the new parts - maybe these O-rings are shot and aren't creating any tensions to hold the cup in place. Guess we will find out today |
|
12-31-2020, 10:28 AM | #4 |
Scooby Guru
Member#: 21145
Join Date: Jul 2002
Chapter/Region:
NESIC
Location: Not in my own time
Vehicle:2002 Enemy of Aku |
Did the 6MT come with a shifter? It should have.
Did you check the movement with the 6MT shifter? If you had similar movement, then most likely not your SS shifter. You should not have anywhere near that amount of movement. |
Thread Tools | |
Display Modes | |
|
|