|
|
|
|
Thread Tools | Display Modes |
12-22-2020, 12:10 PM | #1 |
Scooby Newbie
Member#: 521075
Join Date: Dec 2020
|
06 Sti trans into 03 wrx front wheels not spinning
So I’m not sure if anyone has ever ran I to this problem or would know what is wrong but I put an 06 six speed into my 03 wrx everything went in well it’s all bolted up to my motor cv axles in going on all gears blead the clutch and for some reason my car doesn’t wanna roll forward or backwards now, I unbolted the driveshaft and it spins freely in neutral jacked the rear end of the car up my rear wheels spin freely when not connected to the driveshaft so I jacked the front end of my car up and I can’t spin the front wheels because they have so much resistance. So I started the car everything was fine I put it in first and as soon as I start letting off the clutch a grabs and starts moving but as soon as I let off the gas it feels like I’m pushing my brakes, same in reverse I checked my E brake didn’t adjust anything in the rear and my brakes are fine and I didn’t touch anything on those does anyone have any idea what it could be I’m using 06 Sti Front CV axle‘s in my 03 wrx hubs and torqued to them down to about 165 pounds.
* Registered users of the site do not see these ads.
|
12-22-2020, 01:13 PM | #2 |
Scooby Specialist
Member#: 175624
Join Date: Mar 2008
Chapter/Region:
MWSOC
Location: Wichita, KS
Vehicle:0304 WRX WRX SY WRB |
Are you using 5x114 knuckles to go with the 06 STi axles? look at the back side of the knuckle and see if the axles are binding against the knuckle.
Normally with this swap with 5x100 knuckles, you would use early 04 STi axle stubs, and use your original WRX female axles. If this is your problem, you will need 2x axle stubs 38415AA110 2x axle circlip 805329010 1x Early 2004 STi axle seal LH 806730041 1x Early 2004 STi axle seal RH 806730042 & your original axles Edit: look here, and also check the links in post #2 https://forums.nasioc.com/forums/sho....php?t=1201152 |
12-22-2020, 01:14 PM | #3 |
Scooby Specialist
Member#: 138994
Join Date: Jan 2007
Location: apparently I "spread the hate"
Vehicle:2006 WRX, 6MT, 5x114 |
this right here. incompatibility of 2005+sti front CV shafts with your 2003 wrx front hubs. Better option to get a pair of WRX front CV shafts with male inner joints. Works with the oil seals already in the 6MT. Done.
|
12-22-2020, 09:25 PM | #4 | |
Scooby Newbie
Member#: 521075
Join Date: Dec 2020
|
Quote:
|
|
Thread Tools | |
Display Modes | |
|
|