Reverse lockout sticking after short shift install

UCDgogie · 06-04-2020, 01:02 AM

So i had my kartboy short shifter and bushings installed today in a ‘18 STI. The reverse lockout gets stuck when i pull it all the way up. It goes into reverse fine and when i push it back down, the lockout works. Anyone have any idea why it might be getting stuck?

* Registered users of the site do not see these ads.

Samurai Jack · 06-04-2020, 10:29 AM

Sounds like something is binding w/the cable.

Either take a look at it and fix it or just take it back to whoever did the work and have them fix it.

06-04-2020, 01:02 AM	#1
UCDgogie Scooby Specialist Member#: 123029 Join Date: Aug 2006 Chapter/Region: SCIC Location: west covina, ca Vehicle: 03 MYCHEM wagon PSM	Reverse lockout sticking after short shift install So i had my kartboy short shifter and bushings installed today in a ‘18 STI. The reverse lockout gets stuck when i pull it all the way up. It goes into reverse fine and when i push it back down, the lockout works. Anyone have any idea why it might be getting stuck? * Registered users of the site do not see these ads.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-04-2020, 10:29 AM	#2
Samurai Jack Scooby Guru Member#: 21145 Join Date: Jul 2002 Chapter/Region: NESIC Location: Not in my own time Vehicle: 2002 Enemy of Aku	Sounds like something is binding w/the cable. Either take a look at it and fix it or just take it back to whoever did the work and have them fix it.