View Single Post
Old 06-04-2020, 01:27 PM   #13
Wayne Suhrbier
Scooby Newbie
Member#: 144044
Join Date: Mar 2007
Chapter/Region: South East
Location: Alabama
2006 STI


I picked up a 4" Kurt swivel vise off ebay. It looks kind of funny on the little mill since it takes up almost 1/2 the table.

I found that in the generic clamping kits the T nut doesn't fit in the table I have. I had to grind a couple down by hand in order to clamp a vise so I could mill down more.
* Registered users of the site do not see these ads.
Wayne Suhrbier is offline   Reply With Quote