View Single Post
Old 05-24-2020, 01:41 PM   #7
pottesha34
Scooby Newbie
 
Member#: 476391
Join Date: Oct 2017
Default

I am using the same torque specs and cam cap order on both sides. I have double and triple checked. My verdict so far is the clearance is too tight. However i need specs to confirm. I believe there was some warping in the head due to the head gasket failure. I have talked with the machine shop and a line bore is the only chance of saving the head.
* Registered users of the site do not see these ads.
pottesha34 is offline   Reply With Quote