View Single Post
Old 05-28-2020, 09:14 AM   #301
Homemade WRX
Scooby Guru
 
Member#: 33782
Join Date: Mar 2003
Chapter/Region: MAIC
Location: Milton Keynes, UK
Vehicle:
96 3MI Racing
search FIRST, then PM!!!

Default

Quote:
Originally Posted by Delphi View Post
Has anyone here gone direct port? I've been thinking about going to an Aquamist setup for safety and the fact its the best Methanol Kit on the market without standalone controllers and what not.
I know a Aquamist had their PDM controlled kit (model number escapes me) but running it port style was common from what I recall. If I recall they had the check valves to keep vacuum from sucking fluid into the port as well.

My goofy engineer ass whats to run a tiny nozzle pre compressor (I'm aware of the risks), then another small one post compressor (not enough for it to condense in the intercooler) and then post intercooler.

Get all that heat out. Then again, if you can shoot directly over the valve, and keep your air mass fraction up by not vaporizing the water/meth charge....

Would be an interesting test. I've seen how this principle works with high secondary injectors and the addition time for latent heat of vaporization won out over shooting past the valve.
* Registered users of the site do not see these ads.
Homemade WRX is offline   Reply With Quote