View Single Post
Old 01-27-2021, 08:44 PM   #281
clsmooth
Scooby Specialist
 
Member#: 86394
Join Date: May 2005
Chapter/Region: VIC
Location: West Vancouver
Vehicle:
2000 RS Coupe
2005 Forester X SE

Default

Power-brushed and coated the outside of the driver's rear hub.




In this corner the caliper is essentially new from last time, so this one is a hybrid of an RS piston body and 3rd gen Legacy bracket. I never swapped over just the bracket before, it was easier then I thought.




Passenger-rear is all put back together.



Next is some cleaning and coating of a few surfaces while the ass end is up, but it's too damn cold right now...
* Registered users of the site do not see these ads.
clsmooth is offline   Reply With Quote