View Single Post
Old 10-03-2020, 05:42 PM   #265
clsmooth
Scooby Specialist
 
Member#: 86394
Join Date: May 2005
Chapter/Region: VIC
Location: Vancouver
Vehicle:
2000 RS Coupe
Blue Ridge Pearl

Default

Phase 2: "Footwork" , has begun...

Started with the front of the car as there's not as much too it as the rear.
Swapped in a Whiteline 22mm front swaybar with all the matching hardware, bushings and links. Little tricky getting it snaked passed the header, and also took me a while to figure out which direction it went on cause I wasn't paying attention to how the stock one was oriented before I took it out.





The endlinks-to-bar bolts were an insanely tight squeeze but they got in there. (There's a lot of space between it and the tie-rod, just the angle of the photo).

* Registered users of the site do not see these ads.
clsmooth is offline   Reply With Quote