View Single Post
Old 09-01-2003, 08:43 AM   #22
STI 2 NV
Scooby Specialist
 
Member#: 31748
Join Date: Jan 2003
Chapter/Region: Tri-State
Location: Upstate NY
Vehicle:
'19 WRX STI
Series.Gray

Default

i think a piece that fits right inside the cutout would be an easy make for someone with experience. basically, if my thinking is correct: 1) make a template out of paper or something flexible and easy to cut, 2) trace the template onto a sheet of metal, 3) cut the metal, 4) drill 3-4 holes in the metal, 5) place the metal piece on the bumper, 5) drill holes in the bumper to match the holes, 6) screw the piece down. too me it doesn't seem too tough. my only problem is cutting the metal since i have nothing to do it with. someone around has to have experience or know someone who does. i just don't know anyone around here so i'm kind of out on devising the metal piece.
* Registered users of the site do not see these ads.
STI 2 NV is offline   Reply With Quote