View Single Post
Old 03-05-2006, 09:55 AM   #36
Colin84
Scooby Specialist
 
Member#: 57113
Join Date: Mar 2004
Chapter/Region: MAIC
Location: Annapolis, MD
Vehicle:
2009 Dodge Ram
Blue

Default

It took me a good long while as well. About 5 hours IIRC. Then again my pump is mounted in the trunk sucking out of the stock intercooler sprayer tank. That required a bracket to be built to hold the pump, then run the wiring and pressure line up through the car, continue the pressure line into the engine compartment and extend the wiring by 4' to reach into the glove box where I mounted the controller which required a hole to be drilled in the bottom of the glove box. Once done I went back into the engine compartment and had to pull off the APS topmount (anyone who has one know's they're a biotch), drill the hole and reinstall.

Holy unorganized, run on sentances!
I obviously chose to make my setup a bit more complicated. It is totally stealth and unseeable.
* Registered users of the site do not see these ads.
Colin84 is offline   Reply With Quote